Note:- This
cheat is also known as Gamecube Systems
Alternate starting sounds - Hold Z
while the Gamecube logo appears to hear new sounds.
Hold Z then about one second later hold A to hear
another sound.
Insert four controllers then hold Z on each of them
while the Gamecube logo appears to hear different
sounds.
Change screen refresh rate - Hold B while powering on
the system until the message "Would you like to switch
to 50hz mode?" appears. This allows you to switch the
screen refresh to match that of PAL games. If playing on
a PAL system, the message will be "Would you like to
switch to 60hz mode?", allowing the screen refresh to
match that of NTSC games.
Control starting logo - Hold A while the cube bounces
down to form the "G" logo to spin it.
Set system time and options - Hold A while powering on
the system.
Sent in by Mark Tiller
Change screen refresh rate: Hold B
while powering on the system until the message "Would
you like to switch to 50hz mode?" appears. This allows
you to switch the screen refresh to match that of PAL
games. If playing on a PAL system, the message will be
"Would you like to switch to 60hz mode?", allowing the
screen refresh to match that of NTSC games.
In-game reset: To restart the Gamecube in many
games, hold B + Y + Start at the title screen.
Use the Game Boy Advance to Gamecube link option without
a Game Boy Advance: This trick requires two
Gamecubes, two televisions, and at least one Game Boy
Player. The purpose of this trick is to eliminate the
need for a Game Boy Advance and also use the special
function it provides on a television screen. Attach the
Game Boy Advance to Gamecube cable into the link cable
slot in the Game Boy Player (without a game in it) that
is attached to the other Gamecube (on which the game
with the special options is played, such as the Tingle
Tuner on Legend Of Zelda: The Wind Waker) or put in the
required game that may be required for other options
(such as the Metroid Prime and Metroid Fusion hookup).
|